Thread: Pond Racer Build Thread
View Single Post
 
Old 09-06-2009, 07:39 AM
silveroxide's Avatar
silveroxide silveroxide is offline
Eternal Member
  
Join Date: Jun 2009
Location: Fayetteville, NC
Posts: 2,563
Total Downloaded: 23.70 MB
Pond Racer
In continuation with the nacelles: I made some half formers to allow the wings to slide through.

The bottom former/bulkhead will also assist in holding steady the landing gear when I get to it.

I started to make the rectangular shape for the rest of the nacelles.

I am embarrassed with my spelling, my graphics program does not have a spell checker and I am not taking my time to recheck my spelling, or my grammar.

The reason for taking about 1/4 inch off the former/bulkhead, is to allow for the connector strip later on. If it was flush with the edge, it would not fit well.
Attached Thumbnails
Pond Racer Build Thread-079.jpg   Pond Racer Build Thread-080.jpg   Pond Racer Build Thread-081.jpg   Pond Racer Build Thread-082.jpg   Pond Racer Build Thread-083.jpg  

Pond Racer Build Thread-084.jpg   Pond Racer Build Thread-085.jpg   Pond Racer Build Thread-086.jpg   Pond Racer Build Thread-087.jpg   Pond Racer Build Thread-088.jpg  

Reply With Quote