Hello everybody,
and now let's come to the last
squeezing & bending round,
it becomes time slowly too.
In the first step it went down from
70 to 50 pins,
subsequently from
50 to 30 pins,
then from
30 to 10 pins.
And finally the long-awaited
Countdown of the last grouplet was approaching:
10 - 9 - 8 - 7 - 6 - 5 - 4 - 3 - 2 - 1 - Cut-off!!!
Hard to believe, but it's done, and so am I!!!
The battlefield is deserted and the pins are safely stowed away.
Therewith the
cutting of the pins to their final length of
6 mm can follow now, which then can be threaded into the
Pin lugs of the
Track shoes, which will finally result in the
8 Crawler chains.
After careful consideration, I've decided not to shorten the pins using the
Miter Cutter, but with the already tried and tested
Single-cut method using the steel ruler angle.
And so it will go on soon,
because
350 pins are already waiting for the final cut.