View Single Post
 
Old 05-25-2021, 01:05 PM
spacerunner's Avatar
spacerunner spacerunner is offline
Member
 
Join Date: Apr 2012
Location: Filderstadt, Germany
Posts: 2,181
Total Downloaded: 5.57 MB
And then also to the cover cap between the eyelets and the small screws,


Source: ARC Forums (crackerjazz)

which I made from Evergreen Sheet Styrene (0,13 mm) with my Punch & Die Set with diameter Ø 0,8 mm and the smallest existing diameter Ø 0,6 mm, which however should only be half as large.



And then the most stressful action came with the gluing of these midgets, which is one more reason for preferring to leave the 16 motors to 3D printing.



As already said, the screws are too large and should only be approx. Ø 0,3 mm, which I've then cut off from a corresponding thin rod,



and tried to apply,



but with which I now stop trying to want sophisticate myself further.

__________________
Greetings from Germany
Manfred
Under construction:
Launch Pad 39A with Challenger STS-6 (1:144)
Reply With Quote