View Single Post
 
Old 08-31-2021, 10:34 PM
smithdr smithdr is offline
Member
 
Join Date: Jul 2016
Location: Federal Way, Washington
Posts: 1,738
Total Downloaded: 865.44 MB
All,
Here's a bit more and a good stopping point while I go to visit my Mom for a week. I did the same routine with the petal spinner of using super glue to harden it and then sanding/filling/priming to make a nice end product. I'll airbrush it later. My petal was my best so far, but still far from being presentable or Polish!


Then I made the prop blades using cut and sanded toothpicks for the interior bracing. I'm trying to show in one picture that it actually spins well!


When I'm back, I'll start on the cylinders but getting the prop done is a good milestone.


More later,
Dan
Attached Thumbnails
Ki-44 Shoki in 1/33rd by GPM-p1010514.jpg   Ki-44 Shoki in 1/33rd by GPM-p1010517.jpg   Ki-44 Shoki in 1/33rd by GPM-p1010518.jpg   Ki-44 Shoki in 1/33rd by GPM-p1010519.jpg  
Reply With Quote