Quote:
Originally Posted by Jim Nunn
Eric
This is a stunning interior and when you finish thw model it will be show stopper.
this maybe of some help
You may want to sand the outside of the frames. I attempted to build the Halinski SB2D-4 Helldiver. When I applied the outer skin I hit a brick wall because the outer skin ended up with a gap of over 1.5mm. I traced the problem back to the laser cut frames which were slightly over sized by around 0.2mm.
Jim Nunn
|
Hi question is did you get your frames from Halinski as well? I built this model and used frames from Halinski and there weren't any issues with them. More likely you had problem with the moisture and your paper card has changed the dimensions.