|
The biggest problems I've had so far:
1. The cardboard I used is slightly thicker when laminated than the slots on the laser cut material meaning the decks were a tight fit and had to be fitted or the slots ground down a bit and glued once in place.
2. The spray adhesive overspray gets on your hands and roller and transfers to the top of the model as smudges. Sometimes you can scratch/rub it off gently and sometimes I use a little isopropanol on a q-tip, however this bleaches the decks slightly. I've reined it in well enough but I'm thinking a glue stick might be better for reinforced card. How do the spray adhesive fans (I really like it otherwise for smooth coverage) get around the perma sticky overspray while cutting things out?
|