#1
|
||||
|
||||
Tombul Mosque, Shumen / Bulgaria - KAMEA - 1:200
Hello friends of architecture
With my next construction report I am breaking new ground in several respects. After about 30 churches and chapels, I'm trying my hand at a Bulgarian model mosque for the first time. It is the Tombul Mosque. I really liked the Bulgarian model building sheet, so it went on the to do list. Approximately 170 pieces of beautiful hand-drawn graphics are spread across twelve sheets. The construction instructions in written form cannot be deciphered by me due to the Cyrillic spelling. However, the image construction instructions should be enough to reach your goal. With great anticipation of an exciting construction project and kind regards Kurt |
Google Adsense |
#2
|
|||
|
|||
Wow, this is going to look beautiful. How did you acquire this kit?
__________________
Currently in the hanger: Thaipaperwork Martin B-26 'Flak-Bait' In the shipyard: JSC barkentine 'Pogoria' Recently completed: TSMC F-16, S&P Kawanishi N1K1 Kyofu diorama |
#3
|
||||
|
||||
Good luck with the build. I hope it's better than some of their other kits.
I have made a couple and spent too much time trying to make the parts fit. BTW - I bought the kits in Bulgaria many years ago and have never seen them any were since Cheers Mike |
#4
|
||||
|
||||
Wooow! I am not an enthusiast of a sharia but I am very fond of some examples of the sacral architecture of the Muslims. I will follow this very thread with pleasure!
__________________
Andrew aka Viator |
#5
|
||||
|
||||
C’mon. This is a MODELING forum. He’s building an architectural subject. Your personal feelings about religion don’t belong here.
|
Google Adsense |
#6
|
||||
|
||||
Hello everyone
@ Siwi : How did you acquire this kit? Here : - Zeist Bouwplaten - Import, verkoop, ontwerp en productie van papieren schaalmodellen, maquettes en bouwplaten (cardmodels), Modelbouw, Rietveld cutoutmodels it's starting .... I start by reinforcing the large base plate (30 x 41 cm). To do this I use 1 mm gray cardboard twice, I cut out the two fountains... and raise the fountain platform by 1.5 mm. In the water basin, the 2D steps are raised using 1mm cardboard. The first part of the wall... is being prepared... ...glue the cardboard behind, cut out the window openings and insert the window from the back. Sincerely Kurt |
#7
|
||||
|
||||
Hello ...............
I reinforced the arcade arches with 1.5 mm Finn cardboard... and stuck them back onto the wall. Part A1b prepared in the same way... and connected to part A1. Sincerely Kurt |
#8
|
||||
|
||||
Looking good so far!
|
#9
|
||||
|
||||
Thank you dhanners
And further I reinforce the ceiling with 0.5 mm gray cardboard, plus another 1 mm gray cardboard... which is glued on the inside... ...so the ceiling should be strong enough to support the large dome. Sincerely Kurt |
#10
|
|||
|
|||
Looking good. What's the function of the triangle tab on the inside roof?
__________________
Currently in the hanger: Thaipaperwork Martin B-26 'Flak-Bait' In the shipyard: JSC barkentine 'Pogoria' Recently completed: TSMC F-16, S&P Kawanishi N1K1 Kyofu diorama |
Google Adsense |
|
|