Kost Castle - Albatros - 1: ?

[Styrian Spitfire]

And we continue.........

Now insert the prepared 1 mm reinforcements... so this part will also be very stable...

... and can be grown straight away.

Part F... nestles against the wall.

Sincerely
Kurt

[Styrian Spitfire]

Hello

Part F reinforced... and added.

The access ramp follows... where the wall is also reinforced...

... which I like better than just a double thickness of cardboard.

Sincerely
Kurt

[Styrian Spitfire]

Hello everybody .....................

Continue with the no bridge... although I am reinforcing the railing here with 1.5 mm...

...and put the bridge over the small gorge.

After ten hours of building the terrain, it's now the turn of the first building... walls reinforced, windows cut out and connected to the ceiling.

Sincerely
Kurt

[Styrian Spitfire]

Hello everyone

First of all I would like to thank you for the keen interest and the many likes, that makes the model maker happy :thumbup:

and further ....

Now glue the back wall step by step...until the wall ring is closed.

Now to the roof, which gets dirty easily. For this I use watercolors that are wiped out with a sponge... I glue the reinforcements into the previously glued roof.

Due to the reinforcement of the gable, the roof must be shortened by 1.5 mm.

Sincerely
Kurt

[Styrian Spitfire]

And further .......

Reinforce the attic C6 (1 mm)... and place the glued roof on top...

... then put the roof on the building ... Try it on at Burg Berg, but don't glue it yet.

Sincerely
Kurt

[Styrian Spitfire]

..................

Before adding the building, the small gate is built... as I am reinforcing the battlements to 1.5 mm

small modifications are necessary...

... so the battlements look better than the thin version ... gate attached to the bridge ...

...and now place the building.

Sincerely
Kurt

[Styrian Spitfire]

Hello everyone ...........

The next building has lots of windows to reset... thirty-seven of them...

... windows installed, as well as the 1 mm reinforcement for the ceiling... which makes it very stable.

Sincerely
Kurt

[Styrian Spitfire]

And let's continue........

The semicircular tower D7... Install window frames...

Insert windows and reinforcements... and attach the turret to the building

Kind regards
Kurt

[Styrian Spitfire]

Hello

Now the interesting roof construction part D8... First glue in a 1mm reinforcement and cut out a working opening...

... then glue the side with the middle tabs ... then the second side and glue the reinforcement through the work opening

Now the roof can be put on

Sincerely
Kurt

[Siwi]

That's a rather interesting design choice to have the roof with it's own 'floor'. I suppose it gives strength and forms the shape but as you have shown, the problem is how to close the glue tabs.