#11
|
||||
|
||||
just adding the trimmings here and on to the next part
|
#12
|
||||
|
||||
That is really outstanding work!
Enjoying your updates! Cheers! Jim |
#13
|
||||
|
||||
nice design work Dark, your still one of the best gun designers in my eyes mate, always goes that bit futher with the detailing. hope the test build goes ok for ya.
|
#14
|
||||
|
||||
Thanks guys! finished the lower, moving on to the stock
|
#15
|
||||
|
||||
sorry my build looks so coarse, its a 1st test build and i use heavy card
|
Google Adsense |
#16
|
||||
|
||||
looks just fine to me :D
__________________
How shall we **** off oh lord? |
#17
|
||||
|
||||
Quote:
Cheers! Jim |
#18
|
|||
|
|||
That is nice work mate very nice
|
#19
|
||||
|
||||
Is the magazine still going to have the bottom piece?
Since he 416 upper receiver w/hand guard can be purchased separately from the full rifle and attached to an AR-15 lower receiver, and your 416 and the Paper Manufacturing AR-15 both being 1:1 scale, do you think the magazine and stock will be interchangeable between the models? Judging by your lower receiver build, I think this would work. I really like the look of the magazine you showed in the 3D build, and the stock looks like it would add some really nice variety to the AR-15 build I have been planning (just need to get the new office sorted out so I can put the printer in place and install the CISS). The first version of the magazine in the AR-15 package was too small, and the second a bit too large, according to the designer's notes. Then again, the 416 is pretty much an AR-15 with a few problems ironed out, so I might as well build this one, since I was going to set up the AR-15 is a similar configuration. Either way, I'm really looking forward to seeing how this one turns out when it is completed. I hope you'll release it publicly, of course. I'm planning to start a wall in my gaming room similar to Sidewinder's so I can show off my builds. Last edited by aom; 04-14-2011 at 08:31 AM. |
#20
|
||||
|
||||
im not sure of the dimensions of the other ar's vrs mine...ill be honest my scale is 1:1 but i can be off by a few MM from the actual as i eyeball alot of it. as for the magpull on the mag, i forgot to show that in the earlier pics.
and yes i will release when down for free...i never charge for models..i just like the fun of designing it and seein some one else enjoy |
Google Adsense |
|
|