#11
|
|||
|
|||
Great work Igor!
Also your comments about errors are highly appreciated, Thanks |
#12
|
||||
|
||||
Thanks Boris.
Starting to fill engine compartment. Fuel tanks, air filter tubes' rings and engine mounts I didn't glue engine mounts in place. The reason is that there isn't any drawing that's show how to glue them. So i will wait for assembled engine to figure it out. I have a guess, though Errors: None
__________________
Welcome to my gallery |
#13
|
||||
|
||||
Started to assemble engine - air-cooled 4-cylinder Krupp M305.
I think something similar was in Krupp Protze track. Engine block Air fan and oil pan Assembled together Errors: Part 57 to short. This is an axel on with fan sits. Drawing given is to short and i just made it longer, so it would insert into engine block and centre everything
__________________
Welcome to my gallery |
#14
|
||||
|
||||
Lovely work mate.
|
#15
|
||||
|
||||
looking good Igor
__________________
David........... Paper modelling gives you a happy high. currently building. c GAZ 51 ALG 17, wagon 111a. unex DH411 excavator and spitfire Mk 9 |
Google Adsense |
#16
|
||||
|
||||
Great job Igor, another very interesting project. Will keep track of this one!
Erik |
#17
|
|||
|
|||
great to see your fine work again looking great so far
|
#18
|
||||
|
||||
Thanks Mike, David, Erik and Rifleman
Continue with engine cylinders Added spark plugs from scratch Also tried to work with 0.6 rivets.... to small. I'm still choosing the order between paint, cut and glue. Whole tank has more than 500 rivets. I hope i can keep up with that Cylinders assembled on engine block Pay attention that both sides are asymmetrical Errors: None
__________________
Welcome to my gallery |
#19
|
||||
|
||||
Impressive work.
|
#20
|
||||
|
||||
Thanks Michael!
Additional parts for the engine Power unit and engine mounts Now i got exact position of engine mounts on the floor Air filters with mounts Tubes from air filter to cylinder were maid from wire with isolation Errors: Tube pattern number confused with other tube pattern. By 251l, 251 they meant 88l, 88p. And vice versa 88. In addition this pattern was wrong - cylinders on both sides are asymmetrical and there is no chance you can use same pattern for both. Also, connections to cylinders must be vertical and not horizontal, as shown
__________________
Welcome to my gallery |
Google Adsense |
|
|