F-16A Block 10A, IAF - Page 2

**skyman00** · #11 01-30-2018, 10:50 PM

PAM's 1:32
Nice work, Thomas.

**Mike1158** · #12 01-30-2018, 11:27 PM

Nice one dood, it flies.

**YOAVHOZMI** · #13 01-31-2018, 01:17 AM

This model is very beautiful and you have done great work on it.

A small note in your possession, the antenna below the nose, should be under the air intake.

another thing, something related to the model and not on your work, at the base of the horizontal stabilizerl should not be an inflated part on model A ... it only exists in model C.

good work my friend.

Another thing....
My models on scale 1:50 were uploaded by John to DGA site and you can find there the little SUPER MYSTERE , and now the horizontal stabilizer will be good and not greater than it should be ... because I rearranged The files.

YOAV

**maxe** · #14 01-31-2018, 03:49 AM

hello guys, hi Ronan, Isaac, Ofanim

downloaded Paper AircraftModels 1:32
http://paperaircraftmodels.com/models

Danke Yoav!

Thomas
"Jägermeister Citty" Wolfenbüttel, Germany

https://www.google.com/search?q=&tbm...&bih=834&dpr=1

**solo67** · #15 01-31-2018, 04:20 AM

Nice build Maxe
to bad your printer was clogged which made the no color lines pattern

but other then that it is a clean build and a fine one .
how was the parts fitting of this model ? was it accurate ?

**MacSongLi** · #16 01-31-2018, 08:07 AM

Another magnificent build maxe.

Gary

**maxe** · #17 01-31-2018, 08:58 AM

Moshe O: a shit printer!!!!! was it accurate? TOP Modell!!! no problems

A small update

**YOAVHOZMI** · #18 01-31-2018, 09:25 AM

another thing Maxe....

the belly drop tank is upside down.

the flat side is should be up.

YOAV

**MichaelS** · #19 01-31-2018, 11:17 AM

Neat plane. Work area almost too neat!!

**Isaac** · #20 01-31-2018, 03:24 PM

Quote:

Originally Posted by YOAVHOZMI

another thing Maxe....

the belly drop tank is upside down.

the flat side is should be up.

YOAV

Max

This should be an easy fix.

Once you remove the center tank, you can print on regular printer paper the center section where you attached it in the wrong location and glue it over with the new piece. Then you can glue the tank correctly. I used this method on the nose of the Kfir I messed up.

Isaac