Another RCAF Harvard Re-paint

[MacSongLi]

Next up are the main landing gear doors. Pretty straight foward. I did use CA glue to add the landing gear mount to the gear door.


Thanks,
Gary

[MacSongLi]

Horizontal Stabilizer - I've cut out the top and bottom of the H Stab (I scored the front tabs first). I also scored cut and folded the thickener (printed on regular paper so it isn't too thick). All edges on the top and bottom halves of the stabilizer are burnished and edge coloured.


Thanks,
Gary

[Vinalssergio155]

You were very entertained with all this. Everything looks great, very good work in all these details Gary.

[MacSongLi]

Thank you very much, Sergio.


What will be your next build?


Gary

[MacSongLi]

Using a new blade, I cut out the section of the fuselage where the H. stabilizer will be installed. I did a dry fit, and everything looks pretty level.


Thanks,
Gary

[Isaac]

Gary

Even though the elevators are not separated, there is a nice amount of shading giving it the looks of separate controls.


Nice work


Isaac

[MacSongLi]

Originally Posted by Isaac

Gary

Even though the elevators are not separated, there is a nice amount of shading giving it the looks of separate controls.


Nice work


Isaac

Thank you Isaac. I had a difficult time adding the correct shading (and small highlight line). I found that the printed model came out different from what I had drawn on the computer.


Gary

[MacSongLi]

On to the Vertical Stabilizer. I've scored, and cut out the V. stabilizer (part 5). I've also put a very small hole in the top and threaded a short piece of silver thread through the hole and CA glued in the back of the part. This will be the antenna wire. I've also rounded the bottom of the rudder so that it will fit around the former.


Thanks,
Gary

[Vinalssergio155]

Great job in the queue section. Shading looks great. Sorry for not answering your question Gary, I did not see it, already you know I'm building.

[MacSongLi]

Thanks Sergio.


V. Stabilizer all ready for installation.



Gary