#81
|
||||
|
||||
Here's a couple of photos of the tail section completed. As you can see I've added the fairing around the vertical and horizontal stabilizers.
Thanks, Gary
__________________
"Fast is fine, but accuracy is everything" - Wyatt Earp Design Group Alpha https://ecardmodels.com/vendors/design-group-alpha |
#82
|
||||
|
||||
Those fairings have been very good Gary.
|
#83
|
||||
|
||||
Thanks Sergio!
Photo 1: The side intake. I'm trying something a little different than I've previously done. I've made a small former for the front of the intake so that I can try to get the front shape correct. Photo 2 & 3: The cowling is installed, and I've added to the side intake. Here's where I am so far. Thanks, Gary
__________________
"Fast is fine, but accuracy is everything" - Wyatt Earp Design Group Alpha https://ecardmodels.com/vendors/design-group-alpha |
#84
|
|||
|
|||
I liked your model ,looks great !
|
#85
|
||||
|
||||
Gary
Good technique on shaping the intake. Isaac
__________________
My gallery [http://www.papermodelers.com/gallery...v-r-6&cat=500] Recent buildsMeteor F1, Meteor F8, Mig-Ye8, NA Sabre, A-4E Skyhawk,Mig-15 red, Mig-17 repaint |
Google Adsense |
#86
|
||||
|
||||
Thank you Isaac, it seemed to work pretty well.
Gary
__________________
"Fast is fine, but accuracy is everything" - Wyatt Earp Design Group Alpha https://ecardmodels.com/vendors/design-group-alpha |
#87
|
||||
|
||||
Closer shot of the side intake. The second photo is of the installed exhaust.
Thanks, Gary
__________________
"Fast is fine, but accuracy is everything" - Wyatt Earp Design Group Alpha https://ecardmodels.com/vendors/design-group-alpha |
#88
|
||||
|
||||
Onto the tail wheel.
Photo 1: I've got the parts cut out, scored and partial assembled. Photo 2: Tail Wheel Complete Thanks, Gary
__________________
"Fast is fine, but accuracy is everything" - Wyatt Earp Design Group Alpha https://ecardmodels.com/vendors/design-group-alpha |
#89
|
||||
|
||||
Everything looks very neat, clean and delicate. Looks great, very well done Gary.
|
#90
|
||||
|
||||
Thank you for the kind words, and for following, Sergio.
Photo 1: Canopy frames cut and edge coloured. I'm going to make the front canopy open on this kit. Photo 2: I'm using some clear thermaform that Isaac had given to me. Because there are no compound curves in the glass. I'm going to try to form the clear plastic using boiling water and forming over a wood dowel. Fingers crossed. Thanks, Gary
__________________
"Fast is fine, but accuracy is everything" - Wyatt Earp Design Group Alpha https://ecardmodels.com/vendors/design-group-alpha |
Google Adsense |
|
|