#41
|
||||
|
||||
Great fitting work Kurt! The KK model prints are very finely detailed. I built the F104G Starfighter a few years ago and I can highly recommend this one to you should you have run out of ideas what to build next (which I very much doubt as you are keeping yourself amazingly productive!).
Cheers, Erik |
#42
|
||||
|
||||
Hello friends of the Buffalo
Thanks to all your positive rates @ Llaut mallorquin : if you use water colors with Gouache it would be creamy and the paper doīnt wrinkle . Kind regards to my favorit bycicle island After the completion of Queen Luise, you can continue here ... The cover 70 ... is mounted above the instrument panel I will now continue with the parts 76/77 and 79 ... with which the landing gear shaft is covered on the inside With best regards Kurt |
#43
|
||||
|
||||
good work Kurt
__________________
David........... Paper modelling gives you a happy high. currently building. c GAZ 51 ALG 17, wagon 111a. unex DH411 excavator and spitfire Mk 9 |
#44
|
||||
|
||||
The frame structure of the wings from parts 18 to 23 ... glue the landing gear shaft ... ... and glue the frame structure to the fuselage ... install parts 84 in the landing gear shaft Sincerely Kurt |
#45
|
|||
|
|||
Nice clean work, Kurt. I'm taking lots of notes!
Dan |
Google Adsense |
#46
|
||||
|
||||
Hi Dan , itīs my pleasure to inspire you
and further I build the wings in the version with separate rudders ... first cut out and lightly shape ... Cut out the opening for the rudder and landing gear ... the three inner panels .. ... are placed Sincerely Kurt |
#47
|
||||
|
||||
Looking good Kurt. Just one small correction: The movable surface on a wing is called aileron (Querruder), to roll along the longitudinal axis. The rudder is located at the vertical stabilizer, to yaw along the top axis. Sorry, pilot's speak, can't kick the habit.
By the way, what color are you using for touching up the inside surfaces? Cockpit green? Cheers, Erik |
#48
|
||||
|
||||
Hi Erik
thank you for the pilot information , live is learnig without end ... For coloring I allways use simple water colours , I think it must be cockpit green it goes a little further here ... Glue the four-colored flap and then slightly scratch it ... glue the cannon and two small frames into the wing ... ... and glue the strip 112 onto the framework Sincerely Kurt |
#49
|
||||
|
||||
good work Kurt
__________________
David........... Paper modelling gives you a happy high. currently building. c GAZ 51 ALG 17, wagon 111a. unex DH411 excavator and spitfire Mk 9 |
#50
|
||||
|
||||
Thank you David
now letīs go on ... The separate aileron ... glue ... ... and insert ... now I first glue the tab on the landing gear shaft, let it dry well. Sincerely Kurt |
Google Adsense |
|
|