#21
|
|||
|
|||
Really clean work, Kurt. Can't wait until you get to all of those little cowling bumps! I think I'll learn a bit!
Dan |
#22
|
||||
|
||||
Hello Dan, thank you, I'm also excited to see how it goes
Now the stern segment... insert bulkhead... ... and install ... Continue with the parts for the tailplane ... ... insert the skeleton and fold it up ... and immediately put it on to try it out, without glue Kind regards Kurt |
#23
|
||||
|
||||
The elevators follow...again with frames inside Now to the rudder ... frames installed ... ... and folded together ... when attaching the tailplane, the bulkhead of the vertical tail serves as a guide Sincerely Kurt |
#24
|
||||
|
||||
Color comes into play with the rudder ... also when coloring edges ... ... and when assembling ... now glue the rudder Sincerely Kurt |
#25
|
||||
|
||||
Round the parts for the fairing well... and glue them Elevator and rudder attached... and two support struts attached to the underside Sincerely Kurt |
Google Adsense |
#26
|
|||
|
|||
Looks nice, Kurt. I'm always amazed how well those little curved parts fit on these paper models. Well done and nice progress!
Dan |
#27
|
||||
|
||||
Hi Dan , thank you , yes I like this progress to build the little parts
Glue the wing frames from 0.5 mm cardboard ... and cut everything out ... ... assembled ... and first fitting Sincerely Kurt |
#28
|
||||
|
||||
The parts for the landing gear bay promise a tricky task ... first the inner part preliminary rounds ... ... glue step by step ... and color the edges Sincerely Kurt |
#29
|
||||
|
||||
Preliminary rounds of the outer skin and glue the slits with tissue paper ... then first glue on top .. then pull it down, which was very demanding now... in the end I'm quite happy with the result ... now only the wings should fit ...... Sincerely Kurt |
#30
|
||||
|
||||
Preparing the wing... Installing tabs and tensioners... ... fold the wings together ... and try them on for the first time without glue Sincerely, Kurt |
Google Adsense |
|
|