F-16a Netz (Yoav design) - Page 3

**paperengineer** · #21 12-14-2022, 03:48 AM

Very clean work Shalom!

**MacSongLi** · #22 12-14-2022, 05:57 AM

Very nice work Shalom. You're correction on the lower skin turned out great.

Gary

**Erik Zwaan** · #23 12-14-2022, 02:59 PM

Nice progress Mor! The wings require quite a bit of dry-fitting I remember and I laminated them on the inside (upper and lower) to increase stiffness and preventing possible "waves".

Looking forward for more,
Erik

**mor54** · #24 12-17-2022, 04:53 AM

Thanks danzam, paperengineer, Gary and Erik for your kind comments. Regarding your comment danzan, I think you are right, but I will check with Yoav.

Shalom Mor

**mor54** · #25 01-07-2023, 08:20 AM

Working on the main landing gear, it is certainly not an easy one. As a base for the main struts I used a 2mm woden stick, and wraped the paper part on it. At the momet I don't have a a full design of the landing gear, it is an evolving process.

Shalom Mor

**MacSongLi** · #26 01-07-2023, 11:44 AM

Great looking legs. Nice job Shalom.

Gary

**ANDREA673JW** · #27 01-10-2023, 11:26 AM

I love this build. really a great model

**Erik Zwaan** · #28 01-11-2023, 10:46 AM

Well done Mor, fitting a landing gear in Yoav's F16 model, and also considering its reduced scale, isn't the easiest of tasks to perform. Keep up the very good work

!

Erik

**mor54** · #29 01-16-2023, 09:00 AM

Thanks Gary, ANDREA673JW and Erik for your comments and interest. Had some progres with the main landing gear.

Shalom Mor

**cafe** · #30 01-16-2023, 09:34 AM

Wow! It's stunning!