#21
|
||||
|
||||
Hi Fred and rmks ,
I also made small slits befor I form the parts Parts 38 / 39 ... fuselage part 40 well before rounds ... Fit frame D1 ... and insert parts 38 / 39 ... ... the engine fuselage part is closed with Spant C. Sincerely Kurt |
#22
|
||||
|
||||
Hello everyone ...
Now to the parts for the cowling ... where again it has to be well preformed ... ... to achieve the convex shape ... now attach the cowling at the front ... ... and glue the engine part to the fuselage. Sincerely Kurt |
#23
|
|||
|
|||
Hi Kurt,
There are some complex curves in there and you are getting them all sorted out. Nice job. Dan |
#24
|
||||
|
||||
Hi Dan , thank you , yes it was a little bit difficult
Hello to all other guys Install two machine guns and part 43 ... above. Windscreen and aiming device ... will not be installed yet . Sincerely Kurt |
#25
|
||||
|
||||
Hello ,
Continue with the rudders... Glue the cardboard frames, glue on the right part... ... and close it with the left part ... now attach the rudder. Sincerely Kurt |
Google Adsense |
#26
|
||||
|
||||
Hello everyone
For the elevators, I insert a piece of toothpick into the curve... elevator attached... ... and control cables installed. Sincerely Kurt |
#27
|
|||
|
|||
Kurt,
The toothpick idea is one I shall steal. I keep trying to (unsuccessfully) roll paper tubes. Great job on the control lines too! Dan |
#28
|
||||
|
||||
Hi Dan , I am back again ,
to steal my idea is very good Hello, it continues.... Now to the frame for the swimmers The marked positions of parts CD and FG seem wrong to me. These parts are intended to guide the struts between the hull and the float. However, according to the construction sketch, these are in the second and fourth segments. Sincerely Kurt |
#29
|
||||
|
||||
Hello everyone
The upper fairing for the float ... I start in the middle with 61d, first fix it at the top ... ...then glue downwards...glue one segment after the other... ... I'll wait with the tip until the underside is glued Sincerely Kurt |
#30
|
||||
|
||||
Hello !
To increase the stability of the side walls, I use 1 mm cardboard strips...Now for the underside of the floats. Parts are well rounded and first glue the front part in the middle .... ... and then fix it to the front ... now add the rear part. Sincerely Kurt |
Google Adsense |
|
|