HEINKEL He - 51 W - MPModel - 1:33 - Page 5

**Styrian Spitfire** · #41 09-14-2023, 12:18 AM

Welcome back....

This is followed by twelve delicate exhaust pipes... built from 48 small parts

After coloring with watercolor, attach the pipes to the engine block... although I slightly blackened the area on the fuselage

Sincerely

Kurt

**Styrian Spitfire** · #42 09-16-2023, 11:17 PM

and further ...

The frames for the upper wing... insert tab 82b in the middle

Pre-round parts 82 well with a tab... and fix in the middle

Sincerely
Kurt

**smithdr** · #43 09-17-2023, 10:49 AM

Looks great, Kurt. Those exhausts look like they must have been a joy to put together!

The final result is awesome, though...

Keep it coming!
Dan

**Styrian Spitfire** · #44 09-19-2023, 11:06 PM

Hi Dan , thank you

Hello everyone ,

First partially glue the upper wing tip... the inner tabs still remain open

Now glue step by step from the inside to the outside... until the entire wing is covered

Sincerely
Kurt

**Erik Zwaan** · #45 09-20-2023, 08:26 AM

Looking good Kurt! Sea planes are not so common on the forum

.

Erik

**Styrian Spitfire** · #46 10-04-2023, 01:39 AM

Hello, I'm back from vacation

Thank you Erik

This is followed by the rudders... which are glued to the wing

Preform part 88 four times and fix it with pieces of wire... now parts 88/89...

... attach to the center of the wing at the top and bottom

Sincerely
Kurt

**Styrian Spitfire** · #47 10-04-2023, 11:47 PM

And further .....

The inner supports 91, first insert and glue 0.5 mm wire... then cut out...

... and use it for testing

Sincerely
Kurt

**smithdr** · #48 10-05-2023, 10:31 AM

Passed the test, Kurt. Looks neat!

Dan

**Styrian Spitfire** · #49 10-06-2023, 01:12 AM

Hi Dan ,
yes , testing is always good

Hello

Now to the four main supports...glued 0.4 mm wire and then cut it out

First plugged in as a test... before the wing is assembled, the windshield with aiming device as well as the pilot and entry bar are installed

Sincerely
Kurt

**Styrian Spitfire** · #50 10-09-2023, 01:03 AM

..................
Now glue the supports... and place the wing on it, then fix it at the top and bottom and let it dry very well

The support under the wing has been removed. Now install the two middle supports, that was a bit tricky but in the end everything worked out.

Sincerely
Kurt