Bus Praga RND - Attimon - 1:24

[whulsey]

Looking good so far.

[Styrian Spitfire]

Hello, here we go again...

Now to the engine, which is to be assembled from 40 parts...and after a few hours of construction...

... the engine ... a model in itself!

Sincerely

Kurt

[Styrian Spitfire]

And we continue...

The next job to be done is the six wheels...starting with the tires, gluing the tread, cambering the side wall with the ball...

... insert it on the inside, first glue the inside at certain points, then cover it all around with glue... the whole thing six times.

Sincerely
Kurt

[Styrian Spitfire]

Hello

Now insert the inner ring... and then cover the back.

Sincerely
Kurt

[Styrian Spitfire]

And further ...

Now shape the rim.. Insert the inner ring...

and to add some color I put gray rivets on... the finished wheels...

...glue it to the brake drums.

Sincerely
Kurt

[Styrian Spitfire]

.................

Part 25, the cooler...where I glue the two parts onto 1.5 mm Finn cardboard, put them together and cover them all around.

Cooler placed as a test, but not yet fixed.

Sincerely
Kurt

[Styrian Spitfire]

And further ....

Continue with construction section b1... I remove the inner wall of part 27...

... window glass inserted ... and the separated part follows .......

Sincerely
Kurt

[Styrian Spitfire]

Hello

The outside and inside are now connected....

... and twice... a few small parts are used on the left.

Sincerely
Kurt

[Styrian Spitfire]

Part 27c with the two tabs... before rounding.

... and glue it together... I provided the back wall with tabs at the top and glued it to the side wall...

... then the second side, so the rear is already somewhat stabilized.

Sincerely
Kurt

[Styrian Spitfire]

Hello, and continue

Part 28e is reinforced with 1.5 mm Finn cardboard ...and thus installed in the rear to give it shape.

Part 27h is divided, pre-rounded... and used on two stages...

... if I share it, I'll be able to do this step better.

Sincerely
Kurt