#51
|
|||
|
|||
I know of the capabilities of a lasercutter, but these are breathtaking!
__________________
Greetings from Holland Willem E. (AKA Ponytail) |
#52
|
||||
|
||||
Quote:
Some "dramatic" image.... Model is close to completion. The last big job will be to build about 20 lifeboats, after that - final touches.
__________________
Finished projects: RMS Mauretania 1/250; SS Canberra 1/250; Toyota Hilux Overdrive; Current projects: SS Michelangelo 1/250 |
#53
|
||||
|
||||
Yes . . . dramatic photo of beautiful work.
How do those funnels work? |
#54
|
|||
|
|||
Just a silent comment...
__________________
Greetings from Holland Willem E. (AKA Ponytail) |
#55
|
||||
|
||||
Quote:
If You asking how assembly vent on then I can say it was a bit challenging but far from any frustration. Haven't used any moisture adding technique, just bent each part again and again until reached required curvature. Sure, some elements a bit cracked, but adding glue and thick paint - corrected everything. Thank you for being interested.
__________________
Finished projects: RMS Mauretania 1/250; SS Canberra 1/250; Toyota Hilux Overdrive; Current projects: SS Michelangelo 1/250 |
Google Adsense |
#56
|
|||
|
|||
you are doing a wonderfull model, a great Liner beautiful one, and also your job, my congratulations
|
#57
|
|||
|
|||
Great model, are you planning to release it like the Canberra ????
|
#58
|
||||
|
||||
looking good , cant wait to see it finished
__________________
Carborundum Illegitimi Ne Herky |
#59
|
||||
|
||||
Thanks CONELLS and herky!
Yes, working on this target. (sorry for delayed answer)
__________________
Finished projects: RMS Mauretania 1/250; SS Canberra 1/250; Toyota Hilux Overdrive; Current projects: SS Michelangelo 1/250 |
#60
|
||||
|
||||
Grateful to announce that Test model of Michelangelo is finished.
The build took much more time than it should. Like always, there are some aspects that I succeeded, and some that I didn't. This was my first build that I've used laser cut hull formers and proved itself - hull geometry appeared straight and precise. Next step - I shall continue my work on preparing instruction and parts to be released. However I'm still planning that one (pre-realise) build must be done by some volunteer. Because too many changes, due to prolonged design and build, were carried on so that it would be a risk to realise very "buggy" issue.
__________________
Finished projects: RMS Mauretania 1/250; SS Canberra 1/250; Toyota Hilux Overdrive; Current projects: SS Michelangelo 1/250 |
Google Adsense |
|
|