DD 886 u.s.s. Orleck design process

[FRD]

Temporary delay, I wasn't happy with that case at all as it was, "makeshift" or, "temporary" until I could get better materials and optimize the design, instead of the angles being scored and folded, I'll just heat form them, with Mylar it's easy.


Another thing that I was not happy about was the depth of the recess, twice as deep as needed, by making this alteration, the reflective tape is no longer require as the trim pieces alone at half the width will, "do the job" quite effectively.


Stay tuned, it shouldn't take long as I now have the proper materials and the model is back out of it's case, it was taken to the ship last week just to show them that it wasn't just, "a figment of my imagination".


Well into the 2D graphics now with a momentary pause to remedy this case.