Trucking - Page 4

**abbycat** · #31 02-19-2013, 08:19 PM

I hope sometime you can make it to Ohio and visit the Dayton museum. They have quite a collection of weird and cool stuff.

**richkat** · #32 02-19-2013, 08:40 PM

Quote:

Originally Posted by murphyaa

Oh, and my over the road adventures will hopefully end soon. I've signed up for a dedicated route hauling Harley-Davidson Motorcycles and parts between Arizona, Utah, Kansas and Texas.

That's cool Aaron, glad to here that......Rich

**Scott K** · #33 02-19-2013, 08:40 PM

Aaron, I was going to suggest you take a look at what was left of USS Inaugural, while you're in St Louis, but it looks like it may be a month too late. USS Inaugural To Finally Emerge From Her Watery Grave | St. Louis Public Radio

I'm glad I had a chance to walk her decks back in '73 when I did. Too bad I didn't have a camera back then. It was fun cranking the forward gun around, and pointing it at the Arch.

Scott K.

**murphyaa** · #34 03-07-2013, 03:01 AM

I just started a dedicated route hauling Harley-Davidson motorcycles and parts around the country.

**KCStephens** · #35 03-07-2013, 08:42 AM

Thats great news Aaron. Harley's East coast mfg plant is located just about 2 minutes down the road from me here in York, PA. Hope to see you some time.

**murphyaa** · #36 03-07-2013, 09:37 AM

I'm actually heading to York, Pennsylvania right now. I'm not going to the manufacturing plant but to a broker that ships the bikes.

**murphyaa** · #37 03-14-2013, 05:14 PM

Well, I'm in Kansas City, Missouri now (Well Kearny, Missouri to be exact) and my load won't be ready to go until tomorrow morning. So now I have to find something to do. Any suggestions?

**willygoat** · #38 03-14-2013, 06:17 PM

Get some BBQ. Arthur Bryants or Gates are tasty.

**murphyaa** · #39 03-21-2013, 04:04 PM

I'm noticing with this new route that I get to do a lot of sitting. Not sue yet if that's a good thing. Now I'm just outside Louisville, Kentucky with a delivery appointment for tomorrow.

**willygoat** · #40 03-21-2013, 04:10 PM

Time to crank on some new models!