#1
|
|||
|
|||
Aston Martin DB5 007 Goldfinger builld
Hello everyone ,
Recently , I build an Aston Martin DB5 Goldfinger car papercraft The model was design by Dave's Card Collection in the Koolwheels series I modified the build with the extended battering ram Here are some of the build photos: |
Google Adsense |
#2
|
||||
|
||||
I like the rams.
what an interesting colour? I like it. How did you achieve that? I tried to make it as silver as possible...I may have gone a bit light with it. But its definitely all silver/gray.
__________________
SUPPORT ME PLEASE: PaperModelShop Or, my models at ecardmodels: Dave'sCardCreations |
#3
|
|||
|
|||
I achieved the colour , most likely from the glue I applied onto the model , or it could be my printer , printing it slightly darker. I think it's likely to be the white glue I used
|
#4
|
||||
|
||||
ahh. I see the shiny reflections now.
some glues do go a little foggy and/or yellowish. maybe try a spray clearcoat next time? I use a clear lacquer as my page sealer now, and I often use it on finished models. Its cheaper than those preservatives and photo sealers, and lacquer works better than acrylic clearcoats (in my opinion). I can spray it lightly to avoid too much sheen... it evens out the colour and makes some things a bit more vibrant. Or I can spray it on heavier (more coats) to give a glossy finish. just make sure you seal the printed page before you cut out parts, or the final clearcoat could cause bleeds and blur in the ink print.
__________________
SUPPORT ME PLEASE: PaperModelShop Or, my models at ecardmodels: Dave'sCardCreations |
#5
|
|||
|
|||
Thanks for the advice , I will try to use a clear lacquer spray next time
|
Google Adsense |
|
|