Apollo 13 LM-7 Aquarius / UHU02 - Page 2

**mk310149** · #11 04-24-2014, 02:31 PM

Thanks!

Now going on with the interieur of middle section.
As next the hatch and the many interieur...

**mk310149** · #12 04-24-2014, 02:38 PM

Now it's time to put all the parts into the section ...
Also the safety net...
The problem is the opening of the hatch to CM. You have to deform any parts for this...This has UHU also describe...
As last is to bring in the safety net.

**jagolden01** · #13 04-24-2014, 02:58 PM

Beautiful work! Moving right along, too!

**SCEtoAUX** · #14 04-24-2014, 03:44 PM

That is some good progress on the model. It looks very good and detailed.

**NoahMarjeev** · #15 04-24-2014, 04:10 PM

Thank you Michael for sharing those pictures with us, it is a real pleasure to follow this work in progress

**cardmodeler** · #16 04-24-2014, 07:07 PM

Very nice work. Thanks for sharing!

**tomorrow** · #17 04-25-2014, 02:45 AM

Very nice work! You are so fast! I can not such fast when i make model.

**londonbluemisty** · #18 04-25-2014, 08:05 AM

Great work so far Michael

Perfect for future reference when I get around to this build.....

Wayne

**Tapcho** · #19 04-25-2014, 08:16 AM

Quote:

Originally Posted by londonbluemisty

Perfect for future reference when I get around to this build.....

My thoughts exactly. Very good start and good luck with the rest of it. I'm looking forward when you get to skinning the module.

Tappi

**mk310149** · #20 04-25-2014, 09:54 AM

Thank you for all the good words and wishes!

So now it has been going on again!
A backpack I still have left, almost missed it, but yes UHU had two in the photos ... It was hiding on Sheet 6 ...
But wherever he goes, is not yet to fathom ...

Now put up a few hoses that are attached to the outside (they are of course well later also on the inside, I think). There are so few parts that will probably never see you at the end, unless you build twice - once with and once without the fairing ...
Now it goes to the bay to the hatch to the CM.
Looks like cooling fins - but serves to hold the cover. The inner ring remains (for now?) removable.

For now focus on completing the "ascent module engine" to drive for the resurgence.
After gluing the block the nozzle remains (for now) removable.
This serves well -just like hatch ring- to be able to attach the outer skin later, when I have understand it right (Google already translated the Japanese very idiosyncratic)