#11
|
||||
|
||||
Coming along nicely
Tim |
#12
|
||||
|
||||
The hull and deck look great, nice work.
Gary
__________________
"Fast is fine, but accuracy is everything" - Wyatt Earp Design Group Alpha https://ecardmodels.com/vendors/design-group-alpha |
#13
|
||||
|
||||
Hello again
Part 3b ... attached to the bow Part 3c ... glued at the rear Sincerely Kurt |
#14
|
||||
|
||||
Hello everyone ....
Parts 4 and 5 ... at the bow ... ... and rear grow Sincerely Kurt |
#15
|
||||
|
||||
Hello
For parts 6 and 7, an additional 0.2 mm reinforcement is glued in... and placed on the inside of the ship's side. Assemble parts 8 ... and glue them to the deck Sincerely Kurt |
Google Adsense |
#16
|
||||
|
||||
Coming together quite nicely. The wood texture is very well done on this kit.
Gary
__________________
"Fast is fine, but accuracy is everything" - Wyatt Earp Design Group Alpha https://ecardmodels.com/vendors/design-group-alpha |
#17
|
|||
|
|||
You have done an excellent job of a beautiful and good model. Only flaw in my opinion: It should be full hull. A waterline model always looks funny because they are very rarely exhibited over a water reproduction. A waterline ship model resting on top of a wooden base always looks way out of reality. Some printers like the Polish Maly Modelarz offers the very clever possibility of building either waterline or full hull models.
|
#18
|
||||
|
||||
Hello everyone ,
After a long break here we go again..... The next parts... control and steps installed on board Parts 11 reinforced with 1 mm cardboard ... and cover the sides with strips 11 c Now assemble the scaffolding on the rear deck Sincerely Kurt |
#19
|
||||
|
||||
If I were you I would have been replacing the stairs flight. Schreiber-Bogen is a very good editor but the stairs printed on the flat sheet are slightly spoiling the model. It wouldn't be difficult to make them 3D in this scale - at least they could be cut and bent instead of replaced (see the sketch below).
__________________
Andrew aka Viator |
#20
|
||||
|
||||
Hello
@ Adrew :You're right, there are many options for refining the model, but every now and then I like to build a simple model that I don't spend too long on. Part 12, the roof... glue it together and round it well... ... and place it on the scaffolding, using the mast as a guide Sincerely Kurt |
Google Adsense |
|
|