#21
|
||||
|
||||
Hello
Interior cladding glued, part 26a prepared... glue it to the deck and place the entire deck on the frame frame Deck 30 with attachments...assembled Best regards Kurt |
#22
|
|||
|
|||
Looks good Kurt. Did you need to reinforce any of the decks or was the kit frame sufficient?
|
#23
|
||||
|
||||
Hello rmks ?
The decks have not been reinforced, it sits very well on the frame .................. Hello Parts 34 / 35...assembled and placed... ... the deck is placed on top of it... now stick the tab behind the side wall... ... then connect the top and bottom parts Sincerely Kurt |
#24
|
||||
|
||||
Nice progress Kurt and wonderful sharp pictures. They bring out the fine print of the model very well, and your work is impeccable! Looks like a fun model to make.
Erik |
#25
|
|||
|
|||
part 34 and 35 are where the galley and laundry are (or were). Spent quite a few hours in the scullery there.
|
Google Adsense |
#26
|
||||
|
||||
Thank you Erik
Hello everyone And further ..... Now glue the side wall step by step... and finally stick on the lettering and coat of arms I start gluing the front side wall at the back... and move forward again step by step... ... where there is a discrepancy of up to 1.5 mm inside, which is simply covered up with brown paint Sincerely Kurt |
#27
|
||||
|
||||
and further ...
The planking was reasonably successful... there were small inconsistencies on the bow... ...same thing at the rear...still I'm happy with the result. Thus, the first structural unit (ship hull Above water part) completed Now comes the second structural unit, the underwater hull with the ship stand Sincerely Kurt |
#28
|
|||
|
|||
You make it look easy.
|
#29
|
|||
|
|||
Yes, and getting hull sides on neatly over a long thin profile and having them match up at the bow and stern takes skill and patience.
__________________
Currently in the hanger: Thaipaperwork Martin B-26 'Flak-Bait' In the shipyard: JSC barkentine 'Pogoria' Recently completed: TSMC F-16, S&P Kawanishi N1K1 Kyofu diorama |
#30
|
||||
|
||||
Hello everyone
Continuing with the underwater hull.... First reinforce the frames with the enclosed cardboard... connect the two longitudinal frames with part 42... ... and put the scaffolding together The base plate...glue together with the two tabs Sincerely Kurt |
Google Adsense |
|
|