|
|
|
#1
09-14-2010, 09:25 AM
|
||||
|
||||
|
Technique for designing petal cones?
I have been trying to find a guide on how to design a petal cone on paper, i supposed i could do it in 3d, but here at work i only have a ruler and compass :D. any ideas? Im referring to the types of cones used on airplane noses, bombs, etc fyi...
|
| Google Adsense |
|
#2
09-14-2010, 12:01 PM
|
||||
|
||||
|
You could try Siatki available from GreMir Models GreMir Models . Version 1.0.1 is free under downloads.
|
|
#3
09-14-2010, 03:32 PM
|
||||
|
||||
|
It's a tedious but not impossible work to do it by hand, I recommend at least using the trial version of pepakura (you could still take screenshots and so on) and the like to do the two-and-something hour job in just 5 minutes... [Since you have 3d I don't think I actually needed to say this
__________________
"The world is big" On hold: Fuyuzuki, Zao, Zara, Akizuki, Past works: XP55 Ascender, CA Ibuki, Seafang F32, IS-3, Spitfire V, J-20
|
|
#4
09-14-2010, 03:43 PM
|
||||
|
||||
|
Ya, ive kinda worked out a way to do it on paper, very tedious... and ya, in 3ds max i can do it in seconds im sure, but dont have my laptop at work :P
|
 |
|
|
Linear Mode
