#1
|
|||
|
|||
Coating paper
Hello,
I have some models printed from my printer on paper card stock. A drop of water on the ink, and it bleeds the colors. Is there a spray I can use to coat/seal the paper and protect it? I'm not sure what's best. Thank you!!! |
Google Adsense |
#2
|
||||
|
||||
One way I've seen from other modelers (specifically Edwin Rodriguez of Hermercraft) is to 'seal' the paper with a layer of white glue using the face of a credit card.
This should, in theory, not only prevent the print from damage but also allow for you to apply a gloss or matte spray after finishing the model (should you want to) without the spray being absorbed by the paper. I've tried this method a few times and I absolutely hate it. Too much of a mess and the paper starts to warp as it soaks up the glue. Maybe it's because I use clear glue instead of white :P. There's probably other ways that work a lot better, but that's pretty much the only method I've seen to 'seal' paper. |
#3
|
||||
|
||||
Quote:
Here's an example (from Edwin's YT) Last edited by theOshkoshModeler; 06-02-2023 at 02:10 PM. Reason: Fixed Youtube embed |
#4
|
||||
|
||||
And that's what I get for trying to embed YouTube my third day on the forum :P
I'll just give you the link instead- Tips for papercraft part 3 - Glossy papercrafts - YouTube Last edited by theOshkoshModeler; 06-02-2023 at 02:14 PM. Reason: Added link |
#5
|
||||
|
||||
I use Krylon clear satin spray paint to seal my inkjet printed pages before any cutting/folding/gluing takes place. A couple of light coats in different directions to ensure full coverage is all it takes.
__________________
Regards, Don I don't always build models, but when I do... I prefer paper. Keep your scissors sharp, my friends. |
Google Adsense |
#6
|
|||
|
|||
Faced with exactly the same problem I used Krylon Workable Fixative (used to seal layers of chalk pastel). In the US it will be available at Blick and Michael's. Being unaware of your location I'd say that any pastel fixative (spray can version) would serve just as well.
Derek |
#7
|
||||
|
||||
I have taken to having my models printed on a laser printer instead of using an ink printer. The laser finish I get is resistant to water. It does not run. I pay about $1.50 USD per sheet at FedEx.
|
#8
|
|||
|
|||
Laser printing is more water resistant but the weakness of it is that it can crack and rub off, especially if the paper is curved or folded. I also use a clear coat spray, or else decide in advance if I want to paint over the model with acrylics.
__________________
Currently in the hanger: Thaipaperwork Martin B-26 'Flak-Bait' In the shipyard: JSC barkentine 'Pogoria' Recently completed: TSMC F-16, S&P Kawanishi N1K1 Kyofu diorama |
#9
|
||||
|
||||
Just about any acrylic spray seems to work. I haven't seen Krylon in Australia for years but the local brands seem to work just fine. With acrylic you get a choice of matt. satin and gloss finishes. I've never used gloss so can't comment on that.
Charlie |
Thread Tools | |
Display Modes | |
|
|