|
|
|
#11
08-24-2023, 02:03 AM
|
||||
|
||||
|
Hello...
I usually use sewing needles to apply the glue, instead to use (as once) the toothpicks I put some glue (I use vinylic glue) from the bottle to a little plastic surface and then i pick with the tip of the needle the quantity of glue I need and I apply it to the part. If I have to glue a large part, I use the pick the glue on the long part of the needle and then pass it on the surface I need to glue. There are mainly two reason because I use needles instead of toothpic : 1) They're made of steel and, cleaning the tip of the needle with a X11 blade from the dry glue, it became again fully ready for a new application. 2) I have needles of different lengths : from 5 centimeters up to 20 centimeters...and I use the longer when I have to put little amounts of glue in parts of the model that are very difficult to reach by the lenght of a toothpick ... hoping can be useful Ciao Jp
__________________
"Damn the torpedoes, full speed ahead!" 
|
|
#12
08-25-2023, 03:53 AM
|
||||
|
||||
|
I'm "old school" I just use an old blade on my exacto to apply. (works for me)
__________________
Replicating Excellence-> https://ecardmodels.com/vendors/replicating-excellence
|
|
#13
03-10-2024, 10:06 PM
|
|||
|
|||
|
Hello!
I know you may laugh but I use micro-swabs that are used to apply adhesive for eyelash extensions. You can purchase 300-500 of them on Amazon for about $10 or at any beauty supply store. I hope this helps!
|
 |
|
|
Linear Mode
