#51
|
||||
|
||||
Hardlec, where are you located? (Fill out your profile to avoid this question later). It will help with folks recommending specific products to your area.
__________________
Put on hold build (someday I'll finish): F-35A Lightning II 1:72 Previous builds: cMags' Card Model Builds |
#52
|
||||
|
||||
Hi to all..
i was useing fixative for a long time and was happy with the resalts ...but...since i canged my printer to a newer one i noticed that if i use fixative on the new prints the color of the print changed some -it was getting a red/pink agent to the color ...so after trying some other sprays i found americana sealer/finisher that was giving a good finish and seal to the prints....the only thing is that after it drys out it leaves a coat of fine dust that you need to wipe off :o but it dose not disstort the paper and do not change the prints color...two layers of the stuff are more then enough .
__________________
Moshe O |
#53
|
|||
|
|||
hat about Krylon? It has the advantage toe of being available.
|
|
|